Friday, November 16, 2012

2 Down 1 to Go

Recipe for success:

1 x silicon spatula or a clean soft cloth
1 x roll of white vinyl sticker
1 x roll of mahogany vinyl sticker
5 hours (3 for the large table and 2 for the small)

Step 1: Clean the surface very well or else the sticker won't adhere properly

Step 2: Remove all hardware and legs

Step 3: Measure the sticker over the surface you would like to cover and cut to size. Make sure to leave about an inch extra around just in case the sticker shifts during application or the surface is uneven.

Step 4: Line up the sticker to the edge before removing the backing. When you start sticking it onto the surface, do it a little bit at a time. This would prevent the sticker from adhering to itself and causing you lots of bubbles and grief. While laying the sticker down, use the spatula to remove all the air bubbles. Continue this method until  you have covered the entire area. 

Step 5: Repeat step 4 until the whole surface is covered. 

Step 6: Attach the legs and the hardware back on and then you're done!

Tada! Temporary and reversible fix for furniture!

Socks... or no Socks... that is the question

The Side Kick

No comments:

Post a Comment